+高级检索
Ti-55531升温条件下球状和片状α生长及回溶动力学
作者:
作者单位:

1.南京工业大学材料科学与工程学院先进材料研究院;2.中南大学粉末冶金国家重点实验室

作者简介:

通讯作者:

中图分类号:

基金项目:

国家自然科学基金青年项目(51801101);国防基础科研计划JCKY2018414C020


Thermo-kinetic modeling for the growth/dissolution of α globes and lamella in Ti–55531 under continuous heating condition
Author:
Affiliation:

1.Tech Institute for Advanced Materials School of Materials Science and Engineering,Nanjing Tech University;2.State Key Laboratory of Powder Metallurgy,Central South University

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    本文采用升温热膨胀和SEM观察1K/min升温条件下组织组成为(β+球状α)的Ti-55531合金的组织演变,发现组织演变为片状α析出,片状α回溶,球状α回溶。建立了升温条件下片状析出相的生长和回溶动力学方程和球状析出相的生长和回溶动力学方程,模拟这两种形貌α相的动力学行为,并将计算结果与实验测试结果进行比较。模拟结果发现片状α的生长和回溶受Gibbs-Thomson效应影响,Gibbs-Thomson效应降低片状α尖端的稳定性,使得片状α尖端在低于平衡温度发生回溶。片状α尖端的延长遵循体扩散和界面扩散混合机制控制的动力学,而侧面增厚由体扩散控制,片状α的溶解主要受体扩散的影响。而球状α在低温下生长受扩散速率较低的β稳定元素的体扩散控制,高温下回溶受较高扩散速度Al的体扩散控制。

    Abstract:

    The microstructure evolution of Ti-55531 alloy with (β + global α) microstructure composition under 1K/min heating condition was observed by thermal expansion and SEM, and it was found that the microstructure evolution was α lamellae precipitate, dissolute and α globes dissolute. The kinetics equations of the growth / dissolution of the lamerllar precipitate and spherical precipitate were established. The simulation results showed that the growth and dissolution of lamellar α was affected by the Gibbs-Thomson effect, which reduced the stability of α lamella tips, thus resulting in the dissolution of α lamella tips at lower than the equilibrium temperature. The elongation of the α lamella tips follows the kinetics controlled by the mixed mechanism of bulk diffusion and interfacial diffusion, while the lateral thickening is controlled by bulk diffusion, and the bulk diffusion control dissolution of α lamella. global α growth at low temperature is controlled by the volume diffusion of stable elements with a lower diffusion rate, and the solubility at high temperature is controlled by the volume diffusion of Al with a higher diffusion rate.

    参考文献
    相似文献
    引证文献
引用本文

陈福文,徐广龙,周科朝,常辉,周廉. Ti-55531升温条件下球状和片状α生长及回溶动力学[J].稀有金属材料与工程,2020,49(4):1220~1226.[CHEN Fuwen, XU Guanglong, ZHOU Kechao, CHANG Hui, ZHOU Lian. Thermo-kinetic modeling for the growth/dissolution of α globes and lamella in Ti–55531 under continuous heating condition[J]. Rare Metal Materials and Engineering,2020,49(4):1220~1226.]
DOI:10.12442/j. issn.1002-185X.20190023

复制
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2019-01-07
  • 最后修改日期:2019-02-25
  • 录用日期:2019-03-15
  • 在线发布日期: 2020-05-07
  • 出版日期: