Ar离子辐照对Zr-0.75Sn-1Nb-0.35Fe-0.15Cr合金显微组织和耐腐蚀性能的影响

doi:10.12442/j.issn.1002-185X.20230206

首页 > 过刊浏览>2024年第53卷第6期 >1642-1653. DOI:10.12442/j.issn.1002-185X.20230206

Ar离子辐照对Zr-0.75Sn-1Nb-0.35Fe-0.15Cr合金显微组织和耐腐蚀性能的影响
DOI:
                        10.12442/j.issn.1002-185X.20230206
                    
作者:
                        
                        
                    
作者单位:上海大学
作者简介:
通讯作者:
中图分类号:TL341
基金项目:国家重点基础研究发展计划（973计划）（2022YFB1902400）,国家自然科学基金项目（面上项目，重点项目，重大项目）（52201079）

Effect of Ar Ion Irradiation on Microstructure and Corrosion Resistance of Zr-0.75Sn-1Nb-0.35Fe-0.15Cr Alloy

Author:

Affiliation:

Shanghai University

Fund Project:

摘要

图/表

访问统计

参考文献

相似文献

引证文献

资源附件

文章评论

摘要:

通过熔炼、热轧、冷轧和退火等工艺制备了Zr-0.75Sn-1Nb-0.35Fe-0.15Cr（wt.%）合金板状样品，采用静电加速器在300 ℃下对样品进行注量为1.02×1015和5.1×1015 ions/cm2（对应辐照损伤剂量分别为1和5 dpa）的Ar+辐照，然后将未辐照和辐照样品置于360 ℃/18.6 MPa/0.01 M LiOH水溶液中腐蚀90 d，利用扫描电子显微镜和透射电子显微镜表征分析了辐照前后合金基体显微组织和腐蚀后氧化膜截面显微组织。结果表明，辐照前Zr-0.75Sn-1Nb-0.35Fe-0.15Cr合金为完全再结晶组织，晶粒呈等轴晶，第二相主要为fcc和hcp结构的Zr(Fe,Cr,Nb)2，尺寸主要在50~100 nm范围内；辐照后，合金内形成了型位错环，第二相发生了完全非晶化，但未发现第二相中元素向基体扩散现象。腐蚀90 d后，辐照样品的氧化膜厚度小于未辐照样品，说明Ar+辐照在一定程度上降低了合金腐蚀初期的腐蚀速率。分析认为，Ar+辐照能延缓氧化膜显微组织的演化，降低氧化膜中的等轴晶占比和裂纹数量，同时辐照诱导的非晶化第二相的氧化更慢，使氧化膜更具保护性，从而降低合金腐蚀速率。

Abstract:

Zr-0.75Sn-1Nb-0.35Fe-0.15Cr (wt.%) alloy plates were prepared by smelting, hot rolling, cold rolling and annealing techniques successively. The samples were then irradiated on an electrostatic accelerator with Ar+ to a fluence of 1.02×1015 and 5.1×1015 ions/cm2 (corresponding to 1 and 5 dpa, respectively) at 300 ℃. Both the unirradiated and irradiated samples were exposed to 360 ℃/18.6 MPa/0.01 M LiOH aqueous solution for 90 d. The microstructures of the alloy matrix before and after irradiation and the oxide film formed after corrosion were characterized by scanning electron microscope and transmission electron microscope. The results showed that before irradiation the alloy was fully recrystallized and the grains were equiaxed. The second phase particles were mainly Zr(Fe,Cr,Nb)2 with a fcc or hcp structure, and their size was within the range of 50~100 nm. After irradiation, -type dislocation loops were observed in the irradiated region of the alloy, and the second phase particles were completely amorphous, but the element diffusion from the second phase particles to the matrix was not found. After 90-d corrosion, the oxide film thickness of the irradiated samples was smaller than that of the unirradiated sample, indicating that Ar+ irradiation decreased the corrosion rate of the alloy to some extent at early stage of corrosion. This can be explained by the fact that Ar+ irradiation could delay the microstructural evolution of oxide film, including reducing the proportion of equiaxed grains and the number of cracks in the oxide film, as well as slowing down the oxidation of amorphous second phase particles induced by irradiation, thus enhancing the protectiveness of the oxide film.

参考文献

相似文献

引证文献

引用本文

顾志远,吴悦,林晓冬,姚美意,胡丽娟,梁雪,李毅丰,彭剑超,谢耀平,周邦新. Ar离子辐照对Zr-0.75Sn-1Nb-0.35Fe-0.15Cr合金显微组织和耐腐蚀性能的影响[J].稀有金属材料与工程,2024,53(6):1642~1653.[Gu Zhiyuan, Wu Yue, Lin Xiaodong, Yao Meiyi, Hu Lijuan, Liang Xue, Li Yifeng, Peng Jianchao, Xie Yaoping, Zhou Bangxin. Effect of Ar Ion Irradiation on Microstructure and Corrosion Resistance of Zr-0.75Sn-1Nb-0.35Fe-0.15Cr Alloy[J]. Rare Metal Materials and Engineering,2024,53(6):1642~1653.]
DOI：10.12442/j. issn.1002-185X.20230206

复制

文章指标

点击次数:
下载次数:
HTML阅读次数:
引用次数:

历史

收稿日期:2023-04-12
最后修改日期:2023-07-31
录用日期:2023-08-09
在线发布日期: 2024-06-24
出版日期: 2024-06-17

首页

期刊简介

学术影响

编委会

投稿指南

过刊浏览

常见问答

联系我们

English

引用本文

文章指标

历史