Titanium clad steel plate and micro structure by transient liquid phase diffusion bonding

Home > Archive>Volume 46, Issue 10, 2017 >3156-3159

Titanium clad steel plate and micro structure by transient liquid phase diffusion bonding
DOI:
                        
Author:
                        
Affiliation:National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology,National Engineering Research Center of Solid Waste Resource Recovery,Kunming University of Science and Technology
Clc Number:TB332
Fund Project:National Natural Science Foundation of China (51274037); Key Projects in the National Science & Technology Pillar Program (2011BAE23B00)

Article

Figures

Metrics

Reference

Cited by

Materials

Comments

Abstract:

This paper addresses the issue of transient liquid phase diffusion bonding of pure titanium to 304 stainless steel using aluminum interlayer, at the temperature of 650 ℃ for 2 h under 2 MPa load in vacuum. Then the result was compared with the case of 550 ℃ and 600 ℃. The microstructures, chemical compositions and reaction products of the transition joints were revealed in SEM, EDS and XRD, respectively. The experimental results has shown that, the position of the transient liquid phase diffusion bonding interface is different from that of the conventional thermal diffusion, and aluminum play a mid sole element to prevent iron diffusion to titanium master alloys forming brittle intermetallic phase Fe-Ti. This paper introduces a new technique of Ti-Al-304 stainless steel composite plate diffusion bonding.

Reference

Cited by

Get Citation

[YU Xiao-hua, DONG Xiang, LI Ru-yan, ZHANG Kao-min, ZHAO Yan, GE Jie, LIU Shuhe. Titanium clad steel plate and micro structure by transient liquid phase diffusion bonding[J]. Rare Metal Materials and Engineering,2017,46(10):3156~3159.]
DOI：[doi]

Copy

Article Metrics

Abstract:
PDF:
HTML:
Cited by:

History

Received:August 05,2015
Revised:October 20,2015
Adopted:November 18,2015
Online: December 01,2017
Published:

Home

Introduction

Editorial Board

Submission Guideline

Contact Us

中文

Get Citation

Article Metrics

History